RMT SLD 600

LD6 is a pneumatically operated drill capable of drilling holes in both the hole & top hammer modes, ideally suitable for drilling lead holes for diamond wire cutting of decorative marble, granite rock, etc. This machine has been specially designed keeping in mind operator suitability, so it consists of lubri panel with an “automatic drilling” option along with a large toolbox and covered leveling Jacks with slides for horizontal drilling. A ball joint is provided at the bottom of the mast along with four leveling screws, three anchoring rods with taper bushes, and one adjusting rod for vertical drilling.
Wagon Drill
Wagon Drill
Model # RMT SLD 600
Diameter of hole θ 115 to θ165
Depth of hole - Vertical 30 mtrs.
Length of hole - Horizontal 30 mtrs.
Drill pipe size θ76 mm
Drill pipe length 1.5 mtrs.
Minimum center length of hole from ground 125 mm
Weight (Appx.) 700 kg
Height of rig 2845 mm
Width of rig 690 mm
Rotation unit 6 HP
RPM 0 to 150
Feed Unit 6 HP
Pull up & down 2000 kg
Air requirement @7 Bar 250 CFM
Drilling Rate (Granite) – Feet / Hour 30' / Hour

What is good about it?

  • Horizontal & Vertical Drilling
  • Covered leveling jack for Horizontal Drilling
  • Easy to adjust rods
  • Most suitable for Marble & Granite Mass