RMT SLD 100

LD4 is a pneumatically operated drill capable of drilling holes in both the hole & top hammer modes, ideally suitable for drilling lead holes for diamond wire cutting of decorative marble, granite rock, etc. This machine has been specially designed keeping in mind operator suitability, so it consists of lubri panel with an “automatic drilling” option along with a large toolbox and covered leveling Jacks with slides for horizontal d
rilling. A ball joint is provided at the bottom of the mast along with four leveling screws, three anchoring rods with taper bushes, and one adjusting rod for vertical drilling.
Wagon Drill LD-4
Wagon Drill LD-4
Model # RMT SLD 100
Dimension of hole θ 115 to θ 150
Depth of hole - Vertical 30 mtrs
Length of hole - Horizontal 20 mtrs
Drill pipe size θ 76
Drill pipe length 1.5 mtrs
Minimum center length of hole from ground 125 mm
Weight (Appx.) 600 kg
Height of rig 2500 mm
Width of rig 600 mm
Rotaon unit 4.5 HP
RPM 0 to 50
Feed unit 4.5 HP
Pull up & down 1500 kg
Air requirement 200 cfm
Drilling rate (Granite) - Feet / Hour 15' / Hour

What is good about it?

  • Horizontal & Vertical Drilling
  • Covered leveling jack for Horizontal Drilling
  • Easy to adjust rods
  • Most suitable for Marble & Granite Mass